Processing Parameters of Garment Sewing Operations during Flat Seam Joining

Authors

  • Dubravko Rogale Faculty of Textile Technology University of Zagreb, Department of Clothing Technology, Zagreb, Croatia https://orcid.org/0000-0002-3104-8096
  • Blaž Knez Faculty of Textile Technology University of Zagreb, Department of Clothing Technology, Zagreb, Croatia
  • Zvonko Dragčević Faculty of Textile Technology University of Zagreb, Department of Clothing Technology, Zagreb, Croatia

Abstract

The method of measuring processing parameters in garment sewing operations, employing new measuring system and method of measuring and calculation of processing parameter values, has been presented. Measurements have been done and processing parameter determined - time needed for sewing, sewing machine utilisation ratio, percentage of maximum sewing speed of the machines, average sewing speed, characteristic duration of ali the machine/hand technological procedures and technological operations depending upon the lengs of the flat seams on laboratory samples investigated.

Downloads

Published

1997-02-28

Issue

Vol. 46 No. 2 (1997)

Section

Original scientific paper

License

Copyright (c) 1997 Hrvatski inženjerski savez tekstilaca

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Rogale, D. et al. 1997. Processing Parameters of Garment Sewing Operations during Flat Seam Joining. Tekstil. 46, 2 (Feb. 1997), 75–80.

Most read articles by the same author(s)

<< < 1 2 3 4 5 6 7 8 9 10 > >>